I have a list of a few things I don’t like about my Bounder. One being the lack of a control center and the tank level indicators being by the drivers seat. I decided to make my own above the entry door. This was a good location that was empty. I used a 18/8 thermostat wire to extend the wires. There are 10 wires needed to power this indicator. 2 wires for power and 8 for the sensors. The power wires were tapped in to the cabinet light above the 3rd seat.
I used some popular I had and stained it dark. I didn’t want it to show finger prints. I also put this on a hinge for easy access. I have a piece of tape on the upper right side to pull open until I decide what kind of handle/pull I want to do.
Here is a link to the YouTube Video showing the install.
2 comments
Can you post the video link again? It says not available.
Thanks
That’s interesting – the video does appear to be gone from my YouTube. I will get another made and uploaded this week for. Here is my YouTube channel if you’d like to check back. https://www.youtube.com/channel/UCox11_eOgM-JJT7o1mYwQ-Q